生物分子拉曼散射测定过程中荧光背景的抑制

拉曼共焦技术、表面拉曼增强技术以及降低入射激光强度的方法，被运用于SOD、DNA等生物分子拉曼散身实验中，以抑制其荧光背景，改善光谱质量。     

沉积铁钝化膜的傅立叶变换表面增强拉曼光谱

利用恒电流沉积技术、傅立叶变换表面增强拉曼散射技术现场研究了0 1mol/LNaOH溶液中铁金属电极在不同电位下的表面氧化物的组成。结果表明,在电极预钝化区,表面首先生成的Fe(OH)2可由拉曼谱图中出现的550cm-1表征,证实了以往的研究结果。进入钝化区,表面二价氧化物逐步转化为高价氧化物Fe3O4及α 、δ 和γ FeOOH。在电位回扫的过程中,各氧化产物的还原以及铁表面SERS活性的逐渐消失导致谱峰强度降低。     

Ar-Broadening of isotropic Raman lines in the ν2 band of acetylene

Using a high resolution Raman spectrometer, we have measured Ar-broadening coefficients in the ν₂Q branch of C₂H₂ for 22 lines at 295 K, 20 lines at 174 K, and 16 lines at 134 K. These lines with J values ranging from 1 to 23 are located in the spectral range 1970.9-1974.3 cm⁻¹. The collisional widths are obtained by fitting each spectral line with a Rautian profile. The resulting broadening coefficients are compared with theoretical values arising from close coupling and coupled states calculations. A satisfactory agreement is obtained at room as well as at low temperatures, especially for odd J lines. By comparing broadening coefficients at 295, 174, and 134 K from a simple power law, the temperature dependence of these broadenings has been determined both experimentally, and theoretically.     

利用拉曼型的Jaynes-Cummings模型传送两比特的未知原子态

实现量子态的隐形传送、尤其是多比特量子态的隐形传送在量子信息领域中有非常重要的作用，提出了一种隐形传送两比特未知原子态的方案，在此方案中，用两个两粒子纠缠态代替一个三粒子纠缠态作为量子信道，而且此方案可推广到隐形传送N比特的未知原子态。     

Investigation of the Li1+xV3O8 electrode–organic electrolyte interface by scanning photoelectron microscopy

To investigate the formation of a solid electrolyte interface (SEI) on the Li_1+xV₃O₈ electrode surface in the thermodynamic stability range of the organic electrolyte, we applied scanning photoelectron microscopy (SPEM) to a pristine electrode and to an electrode after ten cycles. The F K-edge absorption spectrum of the cycled electrode showed that LiF forms on the electrode surface during the lithium insertion–extraction process in the Li_1+xV₃O₈/Li cell. The photoelectron spectrum for the cycled electrode showed intense spectral features corresponding to Li 1s, F 2s, F 2p, and P 2p electron signals, whereas these spectral features were of negligible intensity for the pristine electrode. The above results give strong support for the formation of an SEI that consists of LiF and compounds containing phosphorus during operation of the battery. The SPEM images also revealed that the fluorine distribution on the surface of the cycled electrode was inhomogeneous.     

Si微电阻桥温度分布与热传导特性的显微Raman光谱研究

采用显微Raman光谱方法对红外目标模拟器中重掺杂Si微电阻桥单元的热传导特性进行研究，根据Si桥的实际特性建立相应的Raman散射模型，通过测量Raman峰位的移动得到高功率激光辐照下测量点的温度.对Si桥桥面分别进行了沿某些特殊线段的逐点线扫描和覆盖全部桥面的面扫描，得到各点的温升及其分布.用基于有限元分析的软件结合Si桥结构参数对各测量点的温升进行了模拟计算，其结果在热导分布的基本趋势上与实验相一致.实验细致地揭示了热导分布的局域起伏，反映出实际器件的不均匀性，为改进器件设计、优化器件性能提供了实验依据. 关键词： Raman光谱 Si桥 温度分布 热导     

Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

氟化类金刚石薄膜的拉曼和红外光谱结构研究

关键词：     

Possible spectroscopic manifestation of the angular group induced bond alteration (AGIBA) effect in toluene

The most obvious consequence of the concept of aromaticity is the common confidence that in aromatic compounds, bond lengths do not alternate and are between typical to the single and double ones. However, in 1994, performing crystal structure investigations of substituted pyridines and their salts, Krygowski and co‐workers have discovered a very surprising angular group induced bond alteration (AGIBA) effect: It appears that some angular substituents, like methoxy or nitrozo groups, can induce bond alternation in aromatic rings. Crystal studies do not allow one to operate with liquids that are more common in organic chemistry. This paper presents the first possible evidence of spectroscopic manifestations of the AGIBA effect. Raman spectra of the liquid toluene are analyzed. It is found that instead of being single, the line corresponding to the ring breathing vibrations is clearly split by 1.0–1.4 cm^?1, thus indicating the presence of two (cis‐ and trans‐) AGIBA isomers. The energy difference between these isomers estimated in temperature dependent Raman studies is found equal to 6.68 kJ mol^?1. The low‐wavenumber line therefore corresponds to the cis‐AGIBA isomer and the high‐wavenumber line to the trans‐AGIBA isomer stabilized by the AGIBA effect. Copyright © 2007 John Wiley & Sons, Ltd.     

Photo-induced evolution of copper sheets from cluster molecules and its application to photolithographic copper patterning

UV photoexcitation of (t-butylethynyl copper)₂₄ cluster films induces segregation of the crystals into metallic and organic phases and leads to evolve the metallic sheets sandwiched by organic polymers. The growth of the metallic crystals in the plane of the photo-electromagnetic field is attributed due to plasmon-plasmon interaction among nanoparticles embedded in dielectric polymer matrices. The surface enhanced photochemical reaction of residual cluster molecules on the photon incident direction is expected to take an important role for joining the metal particles to produce a metallic sheet. We can apply this phenomenon for photolithographic copper pattern generation on a flexible base plate.